Maxim MAX22444－6快速低功耗四路數字電流隔離器解決方案

Maxim公司的MAX22444–MAX22446是增強的快速低功耗四路數字電流隔離器，采用Maxim公司的專有工藝技術，能在電路間以不同的功率傳輸數字信號，1.8V時1Mbps時每路的功率僅為0.74mW，能經受住5kV RMS電壓60秒，最大數據速率25Mbps或200Mbps，主要用在隔離SPI接口，工業自動化現場總線通信，隔離RS-485/RS-422和CAN，以及電池管理和醫療系統。本文介紹了MAX22444–MAX22446主要優勢和特性，框圖和應用電路，以及評估板MAX22444/5FWEVKIT主要特性，電路圖，材料清單和PCB設計圖。

The MAX22444–MAX22446 are reinforced， fast， low-power 4-channel digital galvanic isolators using Maxim’s proprietary process technology. These devices transfer digital signals between circuits with different power domains， using as little as 0.74mW per channel at 1Mbps （1.8V supply）。 All of the devices in the family feature einforced isolation for a withstand voltage rating of 5kVRMSfor 60 seconds.

The MAX22444–MAX22446 family offers all possible unidirectional channel configurations to accommodate any 4-channel design， including SPI， RS-485， and digital I/O applications. Output enable for the A side of the MAX22445R/S/U/V is active-low， making them ideal for isolating a port on a shared SPI bus since the CS signal can directly enable the MISO signal on the isolator. All other output enables in the MAX22444-MAX22446 family are the traditional active-high.

All channels on the MAX22444–MAX22446M/N are always enabled， however， the default state of the outputs of these devices is selectable.Devices are available with a maximum data rate of either 25Mbps or 200Mbps， and with outputs that are either default-high or default-low. The default is the state the output assumes when the input is either not powered or is open-circuit. See the Ordering Informationand Product Selector Guide for suffixes associated with each option. Independent 1.71V to 5.5V supplies on each side of the isolator also make the devices suitable for use as level translators.

All of the devices in the MAX22444–MAX22446 family are available in a 16-pin wide-body SOIC package with 8mm of creepage and clearance. The package material has a minimum comparative tracking index （CTI） of 600V， which gives it a group 1 rating in creepage tables. All devices are rated for operation at ambient temperatures of -40℃ to +125℃。

MAX22444–MAX22446主要優勢和特性：

Reinforced Galvanic Isolation for Fast Digital SignalsUp to 200Mbps Maximum Data Rate

Withstands 5kVRMS for 60s （VISO）

Continuously Withstands 1500VRMS （VIOWM）

Withstands ±10kV Surge Between GNDA and GNDB with 1.2/50μs waveform

High CMTI （50kV/μs， Typical）

Low Power Consumption0.74mW per Channel at 1Mbps with VDD = 1.8V

1.4mW per Channel at 1Mbps with VDD = 3.3V

3.2mW per Channel at 100Mbps with VDD = 1.8V

Options to Support a Broad Range of Applications2 Maximum Data Rates （200Mbps， 25Mbps）

3 Direction Configurations

Active-High or Active-Low Enable Inputs

2 Fixed Output Default States （High/Low） or Pin-Selectable （M/N Versions）

MAX22444–MAX22446應用：

Isolated SPI Interface

Fieldbus Communications for Industrial Automation

Isolated RS-485/RS-422， CAN

Battery Management

Medical Systems

Safety Regulatory Approvals （Pending）

UL According to UL1577

cUL According to CSA Bulletin 5A

VDE 0884-11 Reinforced Isolation

圖1.MAX22444–MAX22445功能框圖

圖2.MAX22446功能框圖

圖3.MAX22444典型工作電路圖

圖4.MAX22445典型工作電路圖

圖5.MAX22446典型工作電路圖

評估板MAX22444/5FWEVKIT

The MAX22444–MAX22446 evaluation kits （EV kits） provide a proven design to evaluate the MAX22444– MAX22446， reinforced， four-channel， galvanic digital isolators. Two types of evaluation boards are available to support different channel direction configurations， different ENA polarities and different output default settings of the MAX22444–MAX22446 family. The MAX22445FWEVKIT# is fully assembled and tested， and comes populated with the MAX22445FAWE+. The MAX2244XWEVKIT# is a generic board which has U1 unpopulated allowing the user to select a device from the MAX22444-MAX22446 family （Figure 2）。 Both evaluation boards support the wide-body 16-pin SOIC package type. See Table 1 for EV kit options.

The EV kits should be powered from two independent isolated power supplies with nominal output voltage in range from 1.71V to 5.5V. For evaluating the electrical parameters of the device without any isolation between the two sides， a single power supply can also be used.

評估板MAX22444/5FWEVKIT主要特性：

Broad Range of Data Transfer Rates （from DC to 200Mbps）

Four Unidirectional Channels with 3 Different Channel Direction Configurations

SMA Connectors for Easy Connection to External Equipment

Wide Power Supply Voltage Range from 1.71V to 5.5V

Guaranteed Up to 5kVRMS Isolation for 60s

-40℃ to +125℃ Temperature Range

Proven PCB Layout

圖6.評估板MAX22445FWEVKIT外形圖圖7.評估板MAX2244XWEVKIT外形圖

圖8.評估板MAX22444/5FWEVKIT電路圖

評估板MAX22444/5FWEVKIT材料清單：

圖9.評估板MAX2244-6 EVKIT PCB設計圖：左：頂層絲印;右：頂層

圖10.評估板MAX2244-6 EVKIT PCB設計圖：左：L2 GND;右：L3 PWR

圖11.評估板MAX2244-6 EVKIT PCB設計圖：底部