基于嵌入式調試器的網絡通信方法設計與實現

本文介紹了在嵌入式調試器中如何通過以太網口進行嵌入式軟件調試，實現了主機與開發板之間的網口通信。針對具體的嵌入式開發板S3C4510B 對網口驅動和網絡協議進行了研究，裁減了網口驅動和網絡協議的冗余部分，既保證了調試器可以通過以太網進行遠程調試，又能滿足嵌入式系統對資源占用的要求。
關鍵詞：嵌入式開發板；網絡協議；嵌入式調試器

Design and Implementation of Ethernet Communication Method Based on Embedded Debugger WangWenjie, LuanXin (College of Information Science and Engineering, Ocean University of China, Qingdao 266071) Abstract: This paper introduces how to debug embedded software by Ethernet interface in the embedded debugger. The network communication between the host computer and the board has been implemented. To study the Ethernet driver and network protocol is aimed at the embedded board S3C4510B, and the redundant part has been deleted. This implementation both insures the remote debugging by Ethernet and satisfies the request that the embedded system calls for the embedded resources.
Key words: embedded board; network protocol; embedded debugger