資料介紹
These devices provide two independent timing circuits of the NE555, SA555, or SE555 type in each package.
These circuits can be operated in the astable or the monostable mode with external resistor-capacitor (RC)
timing control. The basic timing provided by the RC time constant can be controlled actively by modulating the
bias of the control-voltage input.
The threshold (THRES) and trigger (TRIG) levels are normally two-thirds and one-third, respectively, of VCC.
These levels can be altered by using the control-voltage (CONT) terminal. When the trigger input falls below
trigger level, the flip-flop is set and the output goes high. If the trigger input is above the trigger level and the
threshold input is above the threshold level, the flip-flop is reset and the output is low. The reset (RESET) input
can override all other inputs and can be used to initiate a new timing cycle. When the reset input goes low, the
flip-flop is reset and the output goes low. When the output is low, a low-impedance path is provided between
the discharge (DISCH) terminal and ground (GND).
The NE556 is characterized for operation from 0°C to 70°C. The SA556 is characterized for operation from
–40°C to 85°C, and the SE556 is characterized for operation over the full military range of –55°C to 125°C.
These circuits can be operated in the astable or the monostable mode with external resistor-capacitor (RC)
timing control. The basic timing provided by the RC time constant can be controlled actively by modulating the
bias of the control-voltage input.
The threshold (THRES) and trigger (TRIG) levels are normally two-thirds and one-third, respectively, of VCC.
These levels can be altered by using the control-voltage (CONT) terminal. When the trigger input falls below
trigger level, the flip-flop is set and the output goes high. If the trigger input is above the trigger level and the
threshold input is above the threshold level, the flip-flop is reset and the output is low. The reset (RESET) input
can override all other inputs and can be used to initiate a new timing cycle. When the reset input goes low, the
flip-flop is reset and the output goes low. When the output is low, a low-impedance path is provided between
the discharge (DISCH) terminal and ground (GND).
The NE556 is characterized for operation from 0°C to 70°C. The SA556 is characterized for operation from
–40°C to 85°C, and the SE556 is characterized for operation over the full military range of –55°C to 125°C.
下載該資料的人也在下載
下載該資料的人還在閱讀
更多 >
- TLC556,TLC556Y雙LinCMOS定時器數據表
- NA556 NE556 SA556 SE556雙精度定時器數據表
- 556-04 數據表
- 使用NE556控制脈寬調制
- SPTECH硅NPN功率晶體管2SB556規格書下載 1次下載
- 基于RD-556直流到直流單輸出電源的參考設計
- DC556A-設計文件
- ADL5354ADL556ADL5358革
- DC556A-演示手冊
- HMC556數據表
- DC556A-模式
- DC556A-設計文件
- HMC556 S參數
- HMC556 S-Parameters
- 冠捷D556Q彩顯圖紙
- 基于雙定時器NE556構建的兩音火車喇叭的電路圖 5449次閱讀
- 倒檔喇叭和閃光燈電路的工作原理及注意事項 3463次閱讀
- 多路復用的高分辨率ADC功能的應用實現方案 2223次閱讀
- 4小時順序定時器電路圖 3008次閱讀
- 無穩態多諧振蕩器電路 1.1w次閱讀
- 三款倒計時定時器電路圖 2.6w次閱讀
- 采用TDA4866構成的外部保護信號發生器電路 901次閱讀
- NE555順序定時電路圖分享 6988次閱讀
- 基于SG3525控制的車載逆變電源設計與實現 1.4w次閱讀
- 由555定時器組成的單穩態觸發器 10.8w次閱讀
- 555定時器的電路結構與功能,由555定時器實現看門狗電路 1.3w次閱讀
- 電路設計寶典:淺談555電路設計 1.4w次閱讀
- 基于556芯片的超速報警器電路 5836次閱讀
- 會躲障礙的玩具警車電路圖 2315次閱讀
- 顫音報警電路 1755次閱讀
下載排行
本周
- 1無鉛焊接的可靠性
- 1.03 MB | 5次下載 | 1 積分
- 2GBT1094.11-2022電力變壓器第11部分:干式變壓器
- 14.12 MB | 3次下載 | 免費
- 3PT500齒輪傳動動力學綜合測試實驗臺
- 0.16 MB | 3次下載 | 免費
- 4爬電距離和電氣間隙計算
- 0.75 MB | 2次下載 | 1 積分
- 5SX1308應用電路圖與SX1308升壓電路圖
- 0.18 MB | 1次下載 | 免費
- 6ADC參數單位換算
- 761.94KB | 1次下載 | 免費
- 7串口工具UartAssist5.0.exe
- 0.60 MB | 1次下載 | 免費
- 8UCC38C42 25瓦自諧振復位正激變換器
- 320.6KB | 1次下載 | 免費
本月
- 1ACDC變換器的原理圖免費下載
- 0.26 MB | 65次下載 | 免費
- 2無刷電機控制方案設計合作
- 1.05 MB | 22次下載 | 免費
- 3美的超薄電磁爐TM-S1-09B主板原理圖
- 0.08 MB | 20次下載 | 免費
- 4純電動汽?的主要部件及?作原理
- 5.76 MB | 12次下載 | 5 積分
- 5GP328和GP88S對講機的維修實列資料合集免費下載
- 0.03 MB | 10次下載 | 10 積分
- 6舒爾SLX4無線話筒接收機原理圖:二次變頻超外差部分
- 0.27 MB | 8次下載 | 免費
- 7IP5385_DEMO開發資料
- 1.96 MB | 7次下載 | 2 積分
- 8i.MX Linux開發實戰指南—基于野火i.MX系列開發板
- 17.86 MB | 7次下載 | 免費
總榜
- 1matlab軟件下載入口
- 未知 | 935115次下載 | 10 積分
- 2開源硬件-PMP21529.1-4 開關降壓/升壓雙向直流/直流轉換器 PCB layout 設計
- 1.48MB | 420061次下載 | 10 積分
- 3Altium DXP2002下載入口
- 未知 | 233084次下載 | 10 積分
- 4電路仿真軟件multisim 10.0免費下載
- 340992 | 191363次下載 | 10 積分
- 5十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183329次下載 | 10 積分
- 6labview8.5下載
- 未知 | 81581次下載 | 10 積分
- 7Keil工具MDK-Arm免費下載
- 0.02 MB | 73805次下載 | 10 積分
- 8LabVIEW 8.6下載
- 未知 | 65985次下載 | 10 積分
評論
查看更多